Speaking of Maps

[Imp]

Seabolt you are still restricted to a max map size of 200x160 but create the first then cut a strip off the edge & use it to start the next map. Once you have made the maps you want you can if you wish use cut & paste to select from both these maps & produce the map on the seam.

Then if want maps say size 80x 80 do the following.
1)Select what you want to be the top left corner of the map & drag out an area bigger than the map you want.
2)Paste this in to the top left corner.
3)Now go into prefrences & set map size you want this case 80x80,
go back to map screen & there it is now save it.

If you are unsure how big you want it move mouse over bottom right hex you want in the map read the hex nos & set prefs to that.

By the way I have noticed a lot of light banter on this forum is this acceptable in our politicaly correct age:stir: