Question About Version 4.05.1

[Fortynslow]

Greetings Gentlemen, 

Just updated my Normandy '44 to version 4.05.1 and when I go to select a target, I can now see the full unit designation as seen below, whereas before, If I recall correctly, it said only "XXX Unknown" and the division.  So now, I can tell that these are company size units and not battalion size, which is pretty useful G-2 that was not available in prior iterations.  Not sure if this was intentional or not, but just wanted to point it out.

[ComradeP]

Ah, so it's not just in FWWC. I was beginning to wonder if I missed a change somewhere along the line, but it's due to installing 4.05.1 after all.

It might be worth sending an e-mail about it to [email protected]