Rail Movement

Turner · 07-01-2008, 06:29 AM,

Forgive me but I have to ask, how do you use rail movement? I have units with full movement points remaining at the beginning of the round and try to put them in rail mode but it just won't happen. Does not matter if they are in transport (T) mode or not, they won't go into rail mode. So what am I doing wrong?

:(

The manual is in .docx format, my office CD is stuck in my other PC with a fried MB (yeah I know). Got a new MB some time ago but haven't been arsed to swap it yet. That's my pathetic excuse anyway. :soap:

FLG · 07-01-2008, 06:54 AM,

33vortex Wrote:Forgive me but I have to ask, how do you use rail movement? I have units with full movement points remaining at the beginning of the round and try to put them in rail mode but it just won't happen. Does not matter if they are in transport (T) mode or not, they won't go into rail mode. So what am I doing wrong?

:(

The manual is in .docx format, my office CD is stuck in my other PC with a fried MB (yeah I know). Got a new MB some time ago but haven't been arsed to swap it yet. That's my pathetic excuse anyway. :soap:

A few thoughts

The unit can not be broken

The unit has to be on a rail line

Check your pdt file (F4) for your rail movement capacity isn't zero, i.e..

Russian Rail Capacity: 20 Axis Rail Capacity: 20

**Mr Grumpy** · (This post was last modified: 07-01-2008, 06:56 AM by Mr Grumpy.)

This might be your problem?? :chin:

"Furthermore, units can only convert to Rail Mode if they are in a hex containing a valid rail line and their side must have a rail capacity (defined in Parameter Data). " ;)

*Looks like FLG beat me to the post*